Delta 52 611 Sander Manual Apr 2026

Slide the table assembly onto the rod and secure it with the secondary socket head screw.

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine

: Overall height of 60", weighing roughly 200 lbs. Delta 52 611 Sander Manual

Insert the support rod into the base and tighten the socket head screw.

: Tilts 45° out (away from belt) and 20° in (toward belt). Slide the table assembly onto the rod and

Maintain a minimum clearance of between the table and the sanding belt for safety.

: Clean unpainted surfaces (like the table) with a cloth moistened with kerosene to remove protective coatings. Table Assembly : : Tilts 45° out (away from belt) and 20° in (toward belt)

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation