Use the cable provided and plug it into the port labeled "PC" on the machine (avoid using the port for USB flash drives).
You can connect your computer to the laser cutter via USB or Ethernet. How to setup and use a laser cutter with RD Works
Before connecting your hardware, you must install the software and its drivers correctly. Use the cable provided and plug it into
Once the software is installed, a menu typically appears to install the USB driver. This step is crucial for your computer to recognize the laser cutter. Once the software is installed, a menu typically
In RDWorks, go to the bottom right settings panel and click "Test." If it says "Port test success," you are ready. 3. Basic Operations in RDWorks
Setting up and using a laser cutter with RDWorks involves a few key stages: installation, physical connection, and preparing your design for cutting or engraving. 1. Installation & Setup