Kenwood Kr — 710 Manual

Use TAPE A for your primary deck. Connect the deck's outputs to the "PLAY" jacks and inputs to the "REC" jacks.

Ensure the AC voltage switch (110–120V or 220–240V) matches your local power supply before plugging in. 3. Technical Specifications Specification Power Output 28 watts per channel into 8 Ωcap omega Frequency Response 7Hz to 200kHz Total Harmonic Distortion Signal-to-Noise Ratio 78dB (Phono), 104dB (Line) Dimensions 458 x 123 x 298 mm (approx. 18" x 4.8" x 11.7") 4. Basic Troubleshooting

Boosts bass at low volume levels. Turn off for normal or high-volume listening. Kenwood Kr 710 Manual

Set to "ON" to reduce high-frequency noise like tape hiss or record scratches.

Features 3 red LEDs and 1 green LED. Follow the red lights to center the frequency; the central LED turns green once the servo-lock system has perfectly centered the station to minimize distortion. Use TAPE A for your primary deck

Use the A/B switches to activate speakers connected to the rear terminals. Setting the switch to the center (marked with a prime symbol) activates both sets simultaneously. Audio Filters:

Connect your turntable’s left/right phono plugs here. Use the GND terminal for the turntable's ground wire to prevent humming. Antenna Setup: Connect an indoor 300 Ωcap omega Basic Troubleshooting Boosts bass at low volume levels

Bass and Treble knobs provide a flat response when set to the center. 2. Rear Panel Connections