N_031.mp4

: Measure the signal between Pin 2 (signal) and Pin 1 (ground). Use a voltmeter at test point MP4 on the main board. 2. Angle Sensor Adjustment

The filename n_031.mp4 frequently appears in technical contexts related to crane systems, specifically associated with documentation for the DS 350 and EI 65 series Load Moment Indicators (LMI).

Below is a guide for the assembly and maintenance procedures typically associated with these technical standards. 🏗️ PAT/Hirschmann Crane System Guide n_031.mp4

: Test that the system successfully disables crane functions during an overload condition.

This guide covers the assembly and adjustment of core components found in the system's technical manuals. 1. Cable Reel & Length Sensor : Measure the signal between Pin 2 (signal)

: Fully retract the boom. Turn the potentiometer counter-clockwise until it stops to reset the "zero" point.

: Connect a voltmeter to the main board (Black to MP15 , Red to MP4/MP5 ). Adjust potentiometers P4 or P5 to reach exactly 0.500V (500mV) . Angle Sensor Adjustment The filename n_031

: If replacing the system chip, ensure the notch faces the correct direction to avoid frying the board.