Before powering on, ensure all "hidden" shipping materials are removed to avoid mechanical failure.
: If you have the Combo version, remove the AMS unit from inside the printer and take out any foam pieces under the build plate. Attach Accessories : Before powering on, ensure all "hidden" shipping materials
: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS. Load Filament : Place your filament spool on
: On the touchscreen, go to Utilities > Calibrate . This will perform bed leveling, resonance testing, and vibration compensation. : Unscrew the three screws located next to
: Unscrew the three screws located next to the lead screws (usually marked with arrows or labels) to allow the bed to move.
Feed the filament through the PTFE tube until it reaches the extruder.